|
Detail 1- Excavation of a Pond or Containment Structure
Click for printable, step-by-step instructions |
Detail 2- Anchor Trench Configuration
Click for printable, step-by-step instructions |
|
Detail 3- Deploying a Geotextile Downslope
Click for printable, step-by-step instructions |
Detail 4- Deploying a Geotextile Up a Slope and Trimming For Length
Click for printable, step-by-step instructions |
|
Detail 5- Using Sod Staples to Hold Geotextile Against Wind Uplift
Click for printable, step-by-step instructions |
Detail 6- Unrolling PondGard Geomembrane (Downslope)
Click for printable, step-by-step instructions |
|
Detail 7- Unfolding a Roll of PondGard
Click for printable, step-by-step instructions |
Detail 8- Install a Repair Patch Using a PondGard EPDM Liner Repair Kit
Click for printable, step-by-step instructions |
|
Detail 9- Making 6" QuickSeam Cover Strip Tape Seam
Click for printable, step-by-step instructions |
Detail 10- Making 3" QuickSeam Splice Tape Seam
Click for printable, step-by-step instructions |
|
Detail 11- Priming Cover Strip Tape for Continuation to the Next Roll
Click for printable, step-by-step instructions |
Detail 12- Removing a "Fish Mouth" Gap From a QuickSeam Cover Strip
Click for printable, step-by-step instructions |
|
Detail 13- Removing an Air Bubble From a Tape Seam
Click for printable, step-by-step instructions |
Detail 14- Extend Seaming Technique Into the Anchor Trench
Click for printable, step-by-step instructions |
|
Detail 15- Fitting PondGard Panels Around Pipes
Click for printable, step-by-step instructions |
Detail 16- Installing a QuickSeam Pre-Molded Pipe Boot or Flashing
Click for printable, step-by-step instructions |
|
Detail 17- Fabricating a Pipe Boot or Pipe Flashing With 9" QuickSeam FormFlash
Click for printable, step-by-step instructions |
Detail 18- Fabricating a Pipe Boot or Pipe Flashing With QuickSeam FormFlash (Alternate Version)
Click for printable, step-by-step instructions |
|
Detail 19- Installing PondGard to a Corner Wall
Click for printable, step-by-step instructions |
Detail 20- Adhering PondGard Panel to a Substrate With a Termination Bar or Strip
Click for printable, step-by-step instructions |
|
Detail 21- Installing an Inside QuickSeam Corner Flashing
Click for printable, step-by-step instructions |
Detail 22- Installing an Outside QuickSeam Corner Flashing
Click for printable, step-by-step instructions |
